Due to changes in gnome-common git, an implicit m4 directory is no
longer created during autogen. The attached patch explicitly and
correctly specifies a macro directory.
https://bugzilla.gnome.org/show_bug.cgi?id=706787
When _GTK_FRAME_EXTENTS changes, we need to redo constraints on
the window - this matters in particular if the toolkit removes
invisible borders when a window is maximized, since otherwise
the maximized window will be positioned as if it still has
invisible borders.
https://bugzilla.gnome.org/show_bug.cgi?id=714707
A gulong is not enough to get 64 bits in all arches, so we must
cast it, or we can corrupt the stack.
This was downstream bug bugzilla.redhat.com/show_bug.cgi?id=1002055
https://bugzilla.gnome.org/show_bug.cgi?id=707267
Apparently some connector technologies don't distinguish between
on and off, and there might be valid use cases for running without
any connected monitor.
In that case, just avoid any configuration at all.
https://bugzilla.gnome.org/show_bug.cgi?id=709009
Each level in the tower is initialized by binding the texture for that
level to an offscreen framebuffer and rendering the previous level as a
textured rectangle. The problem was that we were blending the previous
level with undefined data so argb32 windows with transparencies would
result in artefacts. This makes sure to disable blending when drawing
the textured rectangle.
After reading the atom, scale the value from 0xffffffff to 0xff. Not doing so
causes Clutter to truncate the opacity value, and only read the last two digits.
Hence, 0x7fffffff (50%) becomes 0xff (100%).
https://bugzilla.gnome.org/show_bug.cgi?id=727874
After reading the atom, scale the value from 0xffffffff to 0xff. Not doing so
causes Clutter to truncate the opacity value, and only read the last two digits.
Hence, 0x7fffffff (50%) becomes 0xff (100%).
https://bugzilla.gnome.org/show_bug.cgi?id=727874
A careful analysis of mutter's codebase shows that nothing actually
passes anything but 0 to this. gnome-shell has one instance, but it's
most likely a mistake.
Remove the grab_mask field and the one place in keybindings.c that uses it.
The parameter to begin_grab_op is left in for API compatibility reasons.
Since we get the ClientMessage after the surface is created, there's
no good way to synchronize the two streams. In this case, what we
need to do is delay the surface commit until after we get the
ClientMessage. Ideally, we'd be using a better surface system overall
where committing the surface didn't depend on what type it is, but
oh well, this is a good short-term hack for now.
This is effectively the same, but since we lose the xserver.xml protocol
in the new XWayland DDX, we have to use SIGUSR1 anyway, so might as well
switch over now.
