Make sure that clutter is at the right minimum version for the API
we use, and that it is built with the right configure flags, by
checking for subpackage .pcs too.
https://bugzilla.gnome.org/show_bug.cgi?id=708210
On high DPI density displays we create surfaces with a size scaled up by
a certain factor. Even if the contents stay at the same relative size
and position, we need to compensate the scaling both when changing the
surface size, and when dealing with input.
https://bugzilla.gnome.org/show_bug.cgi?id=705915
In order to transparently support high DPI density displays, we must
maintain all coordinates and sizes exactly as they are now — but draw
them on a surface that is scaled up by a certain factor. In order to
do that we have to change the viewport and initial transformation
matrix so that they are scaled up by the same factor.
https://bugzilla.gnome.org/show_bug.cgi?id=705915
Need two passes, because the order we traverse the array is
alphabetical on connector name, not left to right, so we might
see a monitor on the right before we get the offset from disabling
the primary monitor.
https://bugzilla.gnome.org/show_bug.cgi?id=707473
No, holes in the framebuffer are not a good a thing: windows can
get lost there, and the user can get very confused.
Instead, compact the monitors that where previously after.
https://bugzilla.gnome.org/show_bug.cgi?id=707473
The XSync semantics mandate that alarms already expired will not
fire until the counter is reset and the alarm triggered again, so
clients traditionally called get_idle_time() first to see if they
should install the alarm.
This is inherently racy, as by the time the call is handled by
mutter and the reply received the idle time could be different.
Instead, if we see that the watch would have fired in the past,
fire it immediately.
This is a behavior change, but it's a compatible one, as all legacy
clients are calling get_idle_time() first, and it was perfectly
possible for the idle time counter to trigger the alarm right
after the get_idle_time() call.
https://bugzilla.gnome.org/show_bug.cgi?id=707302
Need two passes, because the order we traverse the array is
alphabetical on connector name, not left to right, so we might
see a monitor on the right before we get the offset from disabling
the primary monitor.
https://bugzilla.gnome.org/show_bug.cgi?id=707473
The XSync semantics mandate that alarms already expired will not
fire until the counter is reset and the alarm triggered again, so
clients traditionally called get_idle_time() first to see if they
should install the alarm.
This is inherently racy, as by the time the call is handled by
mutter and the reply received the idle time could be different.
Instead, if we see that the watch would have fired in the past,
fire it immediately.
This is a behavior change, but it's a compatible one, as all legacy
clients are calling get_idle_time() first, and it was perfectly
possible for the idle time counter to trigger the alarm right
after the get_idle_time() call.
https://bugzilla.gnome.org/show_bug.cgi?id=707302
