Add support for non-tiled monitor modes on tiled monitors. This is done
by adding all the other supported modes, except the modes with the
same resolution as the tile dimensions.
https://bugzilla.gnome.org/show_bug.cgi?id=779745
When adding a monitor and all its outputs, don't try to set the logical
monitor of the outputs CRTC if none was assigned. This might happen if
a tiled monitor only uses a subset of the connectors it are connected
via.
https://bugzilla.gnome.org/show_bug.cgi?id=779745
Don't set the CRTC rect and screen size at in read_current(), as those
depends on how the configuration is done. Instead, don't set the CRTC
rect at all, and update the screen dimensions when being configured.
https://bugzilla.gnome.org/show_bug.cgi?id=779745
QT apps reject DnD if the timestamp received in the SelectionRequest
event isn't the same it gave in XdndPosition/Drop client messages.
Bookkeeping and using it in XConvertSelection makes it happy again.
https://bugzilla.gnome.org/show_bug.cgi?id=779757
We are keeping accounting of the focus window as seen by the DnD bridge
right here, so use it instead of the MetaWaylandDragGrab focus as it may
lag behind the real focus (i.e. till the drag source notices the window
and sends XdndEnter to it).
This leads to the window trying to be repositioned more often than
necessary when the drag source takes long to send the XdndEnter client
message, and maybe not repositioned at all if the pointer leaves the
surface while no XdndEnter message was received.
https://bugzilla.gnome.org/show_bug.cgi?id=763246
We currently wait for the selection being cleared by the drag source,
which might not happen on not quite educated clients. This may leave
a stuck XDND grab in the compositor side.
We can actually do a bit better, and clear the grab if:
1) The drag source sent XdndDrop to the wayland drag destination.
2) There's no accepting drag destination and all pointer buttons are
released.
3) As usual, whenever the drag source clears the selection data
https://bugzilla.gnome.org/show_bug.cgi?id=763246
We already do have a texture with an internal format in these paths,
so we should check the required format according to it.
This fixes CoglAtlasTexture (and CoglPangoRenderer indirectly), as
it forces a RGBA format on its texture, but pixel_format_to_gl()
anyway assumed swizzling is performed on the texture, while it is
not the case.
https://bugzilla.gnome.org/show_bug.cgi?id=779234
This is used by the GL driver in order to determine whether swizzling
actually applies given the bitmap and target texture internal format.
If both agree that they store BGRA, then swizzling may apply.
https://bugzilla.gnome.org/show_bug.cgi?id=779234
No XDnD events which notify DnD status change comes in Wayland. To emulate XDnD
behavior, MetaDnd checks whether there is a grab or not when the modal window
starts showing. When there is a grab, it processes the raw events from
compositor, and emits DnD signals for plugin.
https://bugzilla.gnome.org/show_bug.cgi?id=765003
Implement MetaDnd for emitting DnD signals to plugins such as gnome-shell. The
xdnd handling code comes from gnome-shell, and it is hidden behind MetaDnd now.
https://bugzilla.gnome.org/show_bug.cgi?id=765003
When running nested, the pointer can be outside of the stage, meaning
outside of any logical monitor. Handle this when getting the current
logical monitor by falling back to the first logical monitor when the
pointer coordinate is outside of any logical monitor.
https://bugzilla.gnome.org/show_bug.cgi?id=779001
Whenever an EGLOutput consumer is temporary unable to handle
eglStreamConsumerAcquire() operations (e.g. during a VT-switch),
an EGL_RESOURCE_BUSY_EXT error is generated.
This change adds the appropriate error handling to flip_egl_stream() in
order to recover from such errors.
https://bugzilla.gnome.org/show_bug.cgi?id=779112
This change adds descriptions for the following errors to
get_egl_error_str():
- EGL_BAD_STREAM_KHR
- EGL_BAD_STATE_KHR
- EGL_BAD_DEVICE_EXT
- EGL_BAD_OUTPUT_LAYER_EXT
https://bugzilla.gnome.org/show_bug.cgi?id=779112
Ungrabbed pointer motion events over a client window area don't even
reach mutter in X compositor mode, but as a wayland compositor we
process those events which ends up in a call stack like:
- meta_window_handle_ungrabbed_event
- meta_ui_frame_handle_event
- handle_motion_notify_event
- get_control
- meta_ui_frame_calc_geometry
Computing frame geometry is a relatively CPU expensive operation and
doing it on every motion event over a client window is pointless work
since we aren't going to change the cursor or prelight any frame
widget.
This commit special cases the determination of
META_FRAME_CONTROL_CLIENT_AREA using a much faster method. When
continuously moving the pointer over an X (client) window, it results
in a ~40% decrease in mutter cpu usage.
https://bugzilla.gnome.org/show_bug.cgi?id=779436
If the GL implementation/hw supports the GL_*_texture_swizzle extension,
pretend that BGRA textures shall contain RGBA data, and let the flipping
happen when the texture will be used in the rendering pipeline.
This avoids rather expensive format conversions when forcing BGRA buffers
into RGBA textures, which happens rather often with WL_SHM_FORMAT_ARGB8888
buffers (like gtk+ uses) in little-endian machines.
In intel/mesa/wayland, the performance improvement is rather noticeable,
CPU% as seen by top decreases from 45-50% to 25-30% when running
gtk+/tests/scrolling-performance with a cairo renderer.
https://bugzilla.gnome.org/show_bug.cgi?id=779234
Set up things so that if the INTEL_swap_event extension is not present,
but the driver is known to have good thread support, we use an extra
thread and call glXWaitVideoSync() in the thread. This allows idles
to work properly, even when Mutter is constantly redrawing new frames;
otherwise, without INTEL_swap_event, we'll just block in glXSwapBuffers().
https://bugzilla.gnome.org/show_bug.cgi?id=779039
Because the threaded-swap-wait functionality requires XInitThreads(),
and because it isn't clear that it is a win for all applications,
add a API function to conditionally enable it.
Fix the cogl-crate example not to just have a hard-coded dependency
on libX11.
https://bugzilla.gnome.org/show_bug.cgi?id=779039
It's a good guess that the buffer swap will occur at the next vblank,
so use glXWaitVideoSync in a separate thread to deliver a sync event
rather than just letting the client block when frame drawing, which
can signficantly change app logic as compared to the INTEL_swap_event
case.
https://bugzilla.gnome.org/show_bug.cgi?id=779039
When we don't have GLX_OML_sync_control, we still can set the
frame presentation time, but we always use the system monotonic time,
so return that from get_clock_time().
https://bugzilla.gnome.org/show_bug.cgi?id=779039
As previously commented in the code, SGI_video_sync is per-display, rather
than per-renderer. The is_direct flag for the renderer was tested before
it was initialized (per-display) and that resulted in SGI_video_sync
never being used.
https://bugzilla.gnome.org/show_bug.cgi?id=779039
Commits 6dbec6f8, 734402e1 and f041b35b introduced memory leaks by
switching to returning copies instead of the original buffers but
forgetting to free those original buffers.
Some error cases were also not freeing the ->prop buffer as they
should.
https://bugzilla.gnome.org/show_bug.cgi?id=642652
Wayland windows can be zero sized until clients attach a buffer, but
our rectangle code doesn't deal with this case well, in particular,
meta_screen_get_monitor_for_rect() might end up choosing the wrong
monitor for a zero sized rectangle since
meta_rectangle_contains_rect() considers a zero sized rectangle at the
right or bottom edges of another rectangle (the monitor's) to be
contained there.
Since out size limits constraint will enforce a minimum size of 1x1,
we might as well enforce that when setting up the constraint info so
that the correct monitor gets chosen and the single monitor constraint
doesn't move these windows to the wrong one.
https://bugzilla.gnome.org/show_bug.cgi?id=772525
Wayland windows are initially zero sized until clients commit the
first buffer. Despite being invisible, clients are allowed to request
such windows to be fullscreened on a specific output before they
attach the first buffer which means we need to be able to move them.
meta_window_move_to_monitor() doesn't handle this case because these
windows' initial monitor is a placeholder since their initial
coordinates are 0,0+0+0, which results in us using a rectangle as
old_area for meta_window_move_between_rects() that might be to the "right"
of the window causing the move to go further out of the visible
screen's coordinates. This is later "corrected" by the constraints
system but the window might end up in the wrong monitor.
To fix this, we can make meta_window_move_between_rects() accept a
NULL old_area, meaning that we move the window to the new_area without
trying to keep a relative position.
https://bugzilla.gnome.org/show_bug.cgi?id=772525
The reason for the display to be closed may be meta_screen_new()
returning NULL, in which case we don't have a screen to free.
Avoid a segfault on exit by adding a proper check.
https://bugzilla.gnome.org/show_bug.cgi?id=778831
